Edvard Csanyi
1671 awesome technical articles
Electrical engineer, programmer and founder of EEP. Highly specialized for design of LV/MV switchgears and LV high power busbar trunking (<6300A) in power substations, commercial buildings and industry facilities. Professional in AutoCAD programming.
Electric Motor
Few Words About Synchronous Machines
There are two main types of synchronous machine: cylindrical rotor and salient pole. In general, the former is confined to 2 and 4 pole turbine generators, while salient pole types… Read more
Nov 06, 2012 | By Edvard Csanyi
Energy and Power
Aluminium and its Alloys used in Electrical Engineering
Aluminium has been used for many years as a conductor material in almost all branches of electrical engineering. In addition to the pure aluminium, several its alloys are also excellent… Read more
Nov 05, 2012 | By Edvard Csanyi
Energy and Power
Application of Circuit Breakers in IT Networks
IT supplies are used to prevent that a ground fault leads to immediate disconnection of the affected circuit like in a grounded system. Although a first ground fault results in… Read more
Nov 03, 2012 | By Edvard Csanyi
Electric Motor
Motors for Hazardous Areas
Electrical drives/motors that are operated in hazardous areas must be built and engineered so that they cannot become an ignition source. This applies not only to normal operating and starting, but also… Read more
Nov 02, 2012 | By Edvard Csanyi
Protection
Transformer Differential Protection Principles
Similar to bus protections, transformers are protected by differential relays. Inter-winding faults (short circuits) and ground faults within power transformers can be detected by this protection scheme. Failure to detect… Read more
Nov 01, 2012 | By Edvard Csanyi
Energy and Power
Application of 4-pole Switchgear Devices
The majority of low-voltage switchgear is equipped with three contacts in the main circuit, which switch three-phase loads in all poles. In some applications switchgear with four main poles is… Read more
Oct 31, 2012 | By Edvard Csanyi
Energy and Power
Smart and safe protective shutdown of LV system with selectivity
From the point of view of the operational safety and reliability of an entire low-voltage installation, it is usually desirable to specifically isolate the part of a system affected by… Read more
Oct 30, 2012 | By Edvard Csanyi
Transformers
Transformers Are Never Silent
Yes, we all know that transformers are never silent. This is actually quite impossible, but in an environmentally aware, highly regulated world, the issue is not the level of noise,… Read more
Oct 29, 2012 | By Edvard Csanyi
Cables
Short Overview of LV Cable Terminations
A termination is the electrical and physical connection of a cable end to a piece of equipment or another cable. A splice is the electrical connection of a cable end to… Read more
Oct 27, 2012 | By Edvard Csanyi
Electric Motor
Industrial Applications of Brushless Servomotor
A synchronous machine with permanent magnets on the rotor is the heart of the modern brushless servomotor drive. The motor stays in synchronism with the frequency of supply, though there… Read more
Oct 26, 2012 | By Edvard Csanyi
Cables
Corrosion Types Encountered With Power Cables
Introduction Anodic Corrosion (Stray DC Currents) Cathodic Corrosion Galvanic Corrosion Chemical Corrosion AC Corrosion Local Cell Corrosion Other Forms of Corrosion There are numerous types of corrosion, but the ones… Read more
Oct 25, 2012 | By Edvard Csanyi
Cables
The Good, The Bad and The Ugly Cable Insulation
The fundamental understanding of cable insulation properties forms the foundation for assessment of cable operability. These same fundamentals provide the basis for evaluating whether various electrical and physical tests and… Read more
Oct 23, 2012 | By Edvard Csanyi
Electric Motor
Few Words About Three-Phase Alternator
The three-phase alternator, as the name implies, has three single-phase windings spaced such that the voltage induced in any one phase is displaced by 120º from the other two. A… Read more
Oct 20, 2012 | By Edvard Csanyi
Energy and Power
Testing and Commissioning of Current Transformer
1. Objective 2. Test Equipment Required 3. Test procedures Mechanical Check and Visual Inspection Insulation Resistance Test Polarity Test Secondary/Loop Resistance Test Burden Test (optional test) Magnetization Curve Test (optional… Read more
Oct 19, 2012 | By Edvard Csanyi
Transformers
Definitions of Voltage Transformer Parameters
Rated voltage factor Rated primary voltage (Up) Rated secondary voltage Accuracy power Accuracy class Voltage ratio error Phase or phase displacement error Rated thermal limiting output The voltage transformer must… Read more
Oct 18, 2012 | By Edvard Csanyi
