Electronics
Should We Blame Supplier For Voltage Dips and Transients?
Voltage dips and transients are usually blamed on the supplier, but this is often unfair. There are many potential on-site causes; for example, starting of heavy loads may cause voltage dips and switching of inductive loads will generate transients. Let’s… Read more
Mar 11, 2015 | By Edvard Csanyi
Energy and Power
Why it’s important to know which type of power factor correction to use
It’s important to understand where the capacitors are to be installed for a better exploitation of such advantages. There are no general rules applicable to every type of installation and, in theory, capacitors can be installed at any point, but it… Read more
Mar 09, 2015 | By Edvard Csanyi
Energy and Power
Nine Recommended Practices for Grounding
Grounding and bonding are the basis upon which safety and power quality are built. The grounding system provides a low-impedance path for fault current and limits the voltage rise on the normally non-current-carrying metallic components of the electrical distribution system…. Read more
Mar 06, 2015 | By Edvard Csanyi
Energy and Power
6 recommended practices for increasing the power quality
Power quality concerns have traditionally focused on harmonics, which are generated by nonlinear loads, although there are many other concerns regarding isolating sensitive loads from transient disturbances, uneven ground potentials, or phase imbalances. Poor power quality affects the reliable operation of computers and… Read more
Feb 27, 2015 | By Edvard Csanyi
Energy and Power
The most typical indices for measuring power quality disturbances
There are various methods for categorizing the severity of power disturbances. The most typical indices for measuring power quality disturbances are listed and explained below: Distortion factor Crest factor Notch area Recovery time Displacement power factor Total power factor K… Read more
Nov 28, 2014 | By Edvard Csanyi
Energy and Power
10 most common power disturbances that make our life difficult
As you know, deviation from sinusoidal form at the nominal voltage level is actually a power quality issue or power disturbance, defined as “any deviation from the nominal value (or from some selected thresholds based upon tolerance) of the AC… Read more
Aug 22, 2014 | By Edvard Csanyi
Energy and Power
The real truth behind household power savers
A household power low voltage saving devices has recently received a lot of attention from both consumers and manufacturers. It is generally used in residential homes to save energy and to reduce electricity bills. It is a small device which… Read more
Mar 07, 2012 | By Jignesh Parmar
Energy and Power
How reactive power is helpful to maintain a healthy system
We always tend to reduce reactive power to improve system efficiency. This is acceptable at some level. If the system is purely resistive or capacitance, it may cause problems in the Electrical system. AC systems supply or consume two kinds… Read more
Aug 29, 2011 | By Jignesh Parmar
